November 09, 2005
 
FFV Reference Info (incl E10 v E20+ debate)
FFV Reference
Required modifications (per Volvo):
- materials for fuel hoses, valves, seals and bushings are strengthened to deal with the increased corrosiveness of ethanol
- different injection system (v. standard gas) with recalibrated software
- a fuel sensor measure the mix of fuel in the gas tank and communicates with the injection system to get the appropriate mix and timing settings
- some vehicles may also include an engine heater to optimize cold-starting.

Debate on E20 and other ethanol blends that exceed 10% for non-FFV use


Durability
- Australian discussion on permissible limit (2002) – Original limit (2000) was only 7.8% based on the maximum oxygen content limit; this was later revised to 10%, or 3.5% oxygen content. This discussion was driven by the creation of a task force to consider higher percentages, from above 10% up to 20%. The local car industry (FCAI) opposed a proposal to allow for up to 20% ethanol because of engine calibration and durability issues.- Fuel Quality Publications (Australia) – standards for biodiesel, ethanol percentage (E10 v. E20), cetane & octane discussion, etc. - Actual results of testing of cars with different fuels – Gasoline, E10, and E20, tested over 80,000 km (50k mi) in five different types of cars. Full details are here but, there did appear to be slight differences in wear (E20 had more) between fuels. And, there was a substantial increase in the NOx, THM, and CO emissions from E20 cars (the extra oxygen content generated more heat, which burns out the elements in the catalyst). More discussion from Australia.

Fuel economy/efficiency
- ACE Fuel Economy Study (8/24/05) – Performed by Allen Kasperson (fuel research specialist) at Lake Area Vocational Technical Institute (Watertown, SD), using E10, E20 and E30 in three cars (Taurus, Impala, Camry), none of which were FFV equipped. Measuring relative fuel economy (rather than durability) was the purpose of the 600 miles/car test. In addition to the 3 ethanol blends noted, they also tested a version of E10 that had been specially denatured with a mixture of soy diesel and another additive (link to the actual study in PDF). Results: showed that the average loss in fuel economy was substantially less than suggested by the lower BTU content; this suggested that the higher oxygen content enabled a more efficient burning of the overall fuel mixture.

Legal
- MN E20 Law – Requires that 20% of the state’s liquid fuel use be 20% renewable by 2010. If that goal is not met through the use of E10 and E85, the state has mandated the switching of E10 to E20 by 2013. This does not yet have approval or support from the EPA. (more here)
- Thailand – Ford is moving to make its entire fleet compatible with E20 without modification (separate from those with E85 FFV designation).